⚡️ Auto-Conversion: Limit Mode

In this article, we will explain how to set up conversion of your accruals into USDT with a monthly limit – for when you need a predictable amount of stablecoin every month.


What is limit mode?

This is an auto-conversion rule that works on the principle: «convert up to N USDT per month for me». You set a limit and choose which coins to convert from. The system automatically exchanges the accruals of the selected coins into USDT until the specified amount is reached. As soon as the limit is reached, conversion stops, and accruals stay in crypto until the beginning of the next month.

Unlike percentage mode, where a share of every accrual is converted continuously, here what matters is the total amount for the month, not the proportion.

Limit mode works with BTC, LTC, DOGE and ZEC. It only applies to new accruals: to exchange your accumulated balance right away, use «Instant balance exchange».

Fee

1%. It is already included in the conversion rate.



How limit mode differs from percentage mode

  • Percentage mode converts a fixed share of every accrual (for example, 50%) – continuously, regardless of the amount.
  • Limit mode converts accruals in full until the monthly limit in USDT is reached, and then stops.

Only one rule can apply to each source coin – either limit or percentage, not both at once.



How to set up a rule

Open the Auto-conversion section. You will see coin cards: Bitcoin, Litecoin, Dogecoin. Click «Configure» next to the coin you need.

Since two modes are available, the system will ask you to choose a conversion method before setup:

  1. Select «Limit mode» and click «Next».
  2. In the «Convert from» block, tick the source coins – any combination of BTC, LTC, DOGE.
  3. In the «Monthly limit» field, specify the amount in USDT.
  4. Click «Save».

⚡️ The rule will take effect starting from the next accrual.

The limit is single and shared across all selected coins: no matter which coin the accrual came from, progress goes into one scale.



Counting your current USDT balance

If you already have USDT on your balance when the rule is created, the system will ask whether to count it. A window will appear: «You have USDT on your balance. 300 USDT. Count it towards this month’s limit?»

  • «Yes, count it» – the balance will be added to your progress. For example, with a limit of 1 000 the progress will immediately become 300 / 1 000.
  • «No, start from zero» – progress will start at 0 / 1 000.

After you choose, the rule is created.



How progress is calculated

Progress is shown as a bar with a caption like «May 2026 · 594 / 1 000 USDT», with the source coins listed underneath.

  • With each accrual of a selected coin, the system converts the entire accrual into USDT.
  • Progress is counted by the USDT actually received.
  • Progress is shared: accruals from different coins add up to one limit.

Example. Progress is 0 / 1 000. An accrual of ~600 USDT in BTC arrives – it is converted in full, progress becomes 594 / 1 000. Then an accrual of ~200 USDT in LTC arrives – also in full, progress becomes 794 / 1 000.



What happens near the limit

If less is left until the limit than the amount of the accrual, only the missing part is converted, and the rest of the accrual stays in the original coin.

Example. Progress is 940 / 1 000. An accrual of ~600 USDT in BTC arrives. Only 60 USDT is converted (up to the limit), the remaining BTC stays on your balance. Progress becomes 1 000 / 1 000.



When the limit is reached

Once the limit is reached, conversion stops. New accruals are not converted and stay in crypto on your balance. Coins that are not ticked are not converted in any case.

The limit resets automatically at 00:00 UTC (03:00 Moscow time) on the first day of each month. Progress is zeroed, and conversion resumes.



Minimum conversion amount

For a conversion to go through, the amount must exceed the minimum threshold of the exchange:

  • BTC: 0.00001 BTC
  • LTC: 0.001 LTC
  • DOGE: 10 DOGE

If an accrual is below the threshold, no conversion happens, but the amount is not lost – it accumulates. Accumulation is shared across all coins: for example, BTC has accumulated the equivalent of 3 USDT and LTC 4 USDT, together 7 USDT exceeds the threshold, and both coins are converted.

If one order went through and the other was not executed, what went through is counted, and the failed amount stays in accumulation until the next attempt.

Accumulated amounts carry over between months. The monthly reset only zeroes the limit progress – per-coin accumulations are preserved.



How to change a rule

Click the coin card in the «Auto-conversion» section – the editing form will open. Changes take effect from the next accrual.

Changing source coins. You can add or remove ticks at any time. A coin you add will start being converted into the shared limit; a coin you remove will stop.

Increasing the limit. If you raise the limit above the current progress, conversion will continue up to the new value. For example, it was 800 / 1 000 → you raised it to 2 000 → progress is 800 / 2 000, conversion continues.

Lowering the limit below the amount already accumulated. If the new limit turns out to be lower than the progress already accumulated, conversion will stop until the next month. The form warns about this as you type: «The new limit is below the amount accumulated, conversion will be paused until next month». After saving, the progress in the card will be shown in red (for example, 594 / 500 USDT) with the note «Paused until July 1». The USDT already converted stays on your balance.



Pause

There is an «Active / Paused» toggle in the card header. Switch it to pause – new accruals will stop being converted. While paused, the form cannot be edited: to change the rule, resume conversion first.

Progress is preserved while paused. Unpause it and conversion will continue from the same value (for example, from 600 / 1 000).

Pause and the monthly reset. The limit reset on the first day of the month only works for active rules. If a rule is paused, progress is not zeroed when a new month begins – it will be preserved and reset only when you make the rule active again.



Deletion

At the bottom of the page there is a «Delete limit conversion» block with a «Delete» button. The system will ask you to confirm the action.

If there is progress at the moment of deletion, the dialog will show the current amount – for example, «600 / 1 000 USDT accumulated». The current month’s progress is lost when you delete the rule, but the USDT already converted stays on your balance. After deletion, conversion stops, and accruals keep arriving in the original coins.



Conversion history

At the bottom of the «Auto-conversion» section there is a «Conversion history» table. It contains all operations: date and time, source coin, source amount, amount in USDT and the exchange rate.

The history can be downloaded using the «Download» button.



If something went wrong

If the exchange is unavailable or an order was not executed, the accrual stays on your balance in the original coin (or in accumulation), and you receive a notification. The amount is not lost – it will be processed at the next opportunity.

If there is no conversion but the accrual went through, most likely the amount has not yet reached the minimum threshold or the monthly limit has already been reached. Check your progress and the «Conversion history» section.


If anything is unclear, message us in the support chat and we will figure it out together.

Powered by